Super Glue

Wynn's
86-601
  • Description
  • More
  • Specifications

Adhesives

Wynn’s Super Glue is a low to medium viscosity, fast curing, single component Cyanoacrylate Adhesive which can be used for virtually any type of fastening job. Wynn’s Super Glue is specifically formulated for difficult to bond substrates.

Wynn’s Super Glue is less dependent on surface moisture for cure speed than other standard CA grades. Better efficiency and quality combined with cost saving have made Wynn’s Super Glue to be a substitute for repair material. When a thin layer of Wynn’s Super Glue applied between two surfaces comes into contact with atmospheric moisture, a rapid polymerization occurs producing the ultimate bond.

Case size: 12 x 3g

Applications

  • ABS to ABS
  • Wood to Wood
  • ABS to Stainless Steel
  • NBR to Stainless Steel
  • NBR to NBR
  • Stainless Steel to Stainless Steel
  • ABS to NBR
  • Wood to ABS

Directions for use

  1. Make sure the surfaces to be bonded are clean and dry(preferable to solvent-wipe plastics , glass, and rubber, and to acid-treat metals).
  2. Dispense a drop or drops to one surface only. Apply only enough to leave a thin film after compression.
  3. Press parts together and hold firmly for a few seconds. Good contact is essential. An adequate bond develops in less than one minute. (Maximum strength is achieved in 24 to 48 hours).
  4. Wipe off excess adhesive from the top of the container and recap Wynn’s Super Glue if left uncapped, may deteriorate by contamination from moisture in the air.
  5. Because Satlon Wynn’s Super Glue polymerises on contact with moisture surfaces, sometimes a whitening will occur on the surface of the container or the bonded materials. Should this happen, wipe surfaces well with acetone.
Product Code 601
Case size 12 x 3g
Physical state Liquid
Vapour density ≈3
Colour Clear to straw coloured
Flash point 85°C
Odour Sharp, irritating
Barcode 6001296006015
MSDS Download PDF